Dear VASP users.
I wanted to perform bandstructure calculations. Therefore, I first did a self-consistent charge density calculation to obtain the CHGCAR file. This calculation gave a Fermi level of -3.2570 eV for pristine graphene (rectangular unit cell optimized geometrically).
Afterwards, I did several bandstructure calculations using the calculated CHGCAR file for different paths in the Brillouin zone. In fact, I wasn't able to do the calculation for the full path Gamma-X-M-Y-Gamma-M, and thus splitted into 5 small paths (5 different calculations), which are the following:
path 1
0.0000000000000000 0.0000000000000000 0.0000000000000000 ## G
0.5000000000000000 0.0000000000000000 0.0000000000000000 ## X
path 2
0.5000000000000000 0.0000000000000000 0.0000000000000000 ## X
0.5000000000000000 0.5000000000000000 0.0000000000000000 ## M
path 3
0.5000000000000000 0.5000000000000000 0.0000000000000000 ## M
0.0000000000000000 0.5000000000000000 0.0000000000000000 ## Y
path 4
0.0000000000000000 0.5000000000000000 0.0000000000000000 ## Y
0.0000000000000000 0.0000000000000000 0.0000000000000000 ## G
path 5
0.0000000000000000 0.0000000000000000 0.0000000000000000 ## G
0.5000000000000000 0.5000000000000000 0.0000000000000000 ## M
However, I found out that the Fermi levels are different. From path 1 to 5, the Fermi levels are -3.7473, -4.3789, -3.4765, -3.2571, -3.6720 eV.
As you should have noticed, these Fermi levels are different from the one obtained during the self-consistent calculation, except from path 4 (Y-Gamma).
Interestingly, the path Y-Gamma is the one in which we observe the Dirac point (not at K since my graphene unit cell is rectangular instead of hexagonal)
I do not understand why it is like that. May I trust the bandstructures I obtained ?
I point out that the INCAR file was the same for every paths; only the KPOINTS file was changed.
Thanks for your help.
Best regards.
Yan
Differrent Fermi levels with different k-paths
Moderators: Global Moderator, Moderator
- Lian
- Newbie
- Posts: 12
- Joined: Thu Apr 25, 2013 3:04 pm
- Location: Mons, Belgium
Differrent Fermi levels with different k-paths
Last edited by Lian on Mon Mar 03, 2014 6:12 pm, edited 1 time in total.
-
- Administrator
- Posts: 2921
- Joined: Tue Aug 03, 2004 8:18 am
- License Nr.: 458
Differrent Fermi levels with different k-paths
in ab initio codes, the Fermi level is the KS energy of the highest occupied state.
Last edited by admin on Tue Mar 11, 2014 1:23 pm, edited 1 time in total.