check on the force convergence during geometric optimization
Posted: Thu Feb 19, 2009 2:59 am
I'd like to perform a geometric optimization job with criterion using force convergence (EDIFFG=-1E-2).
I can see energy varation as step goes on in OSZICAR file.
However, I don't know where I can see the intermediate infromation on force convergence during the job.
If it is available, where can I see it?
With best regards,
I can see energy varation as step goes on in OSZICAR file.
However, I don't know where I can see the intermediate infromation on force convergence during the job.
If it is available, where can I see it?
With best regards,