Hello,
I am following the "hands on session 3" at this address:
http://cms.mpi.univie.ac.at/vasp-worksh ... sonIII.pdf and VASP does not seem to like this example. I have setup the the INCAR, POSCAR, and KPOINTS files based on the example problem (shown below). The POTCAR file is setup correctly, concatonat 5 times ~/PAW_GGA/Ni/POTCAR >POTCAR When I run VASP, the program terminates and no output files are generated. Can anyone tell me what might be causing this problem? Thank you for your help.
-- INCAR --
general:
SYSTEM = clean Ni(100) surface
ISTART = 0
ICHARG = 2
ENCUT = 270
SIGMA = 0.2
ISMEAR = 2
Spin:
ISPIN = 2
MAGMOM = 5*1
dynamic:
IBRION = 1
NSW = 100
POTIM = 0.2
-- POSCAR --
fcc (100) sufrace
3.53
0.5 0.5 0.0
-0.5 0.5 0.0
0.0 0.0 5.0
5
Selective Dynamics
Cartesian
0.0 0.0 0.0 F F F
0.0 0.5 0.5 F F F
0.0 0.0 1.0 F F F
0.0 0.5 1.5 T T T
0.0 0.0 2.0 T T T
-- KPOINTS --
K-Points
0
Monkhorst-Pack
9 9 1
0 0 0
Ni(100) relaxation will not run.
Moderators: Global Moderator, Moderator
- DMiller
- Newbie
- Posts: 1
- Joined: Tue Nov 23, 2010 6:03 pm
- License Nr.: 5-698
- Location: Morgantown, WV
Ni(100) relaxation will not run.
Last edited by DMiller on Fri Dec 10, 2010 2:28 pm, edited 1 time in total.
-
- Newbie
- Posts: 20
- Joined: Mon Jul 07, 2008 2:24 am
Ni(100) relaxation will not run.
Dear DMiller,
May I please start with the following question: why are you concatinating the POTCAR five times? Since you are only using one type of atom (Ni) then you only need one instance of the Ni potential in the POTCAR file. Please give that a try.
Also, are you using a VASP installation that you know works correctly for other calculations?
May I please start with the following question: why are you concatinating the POTCAR five times? Since you are only using one type of atom (Ni) then you only need one instance of the Ni potential in the POTCAR file. Please give that a try.
Also, are you using a VASP installation that you know works correctly for other calculations?
Last edited by mrm on Mon Dec 20, 2010 4:36 pm, edited 1 time in total.
-
- Administrator
- Posts: 2921
- Joined: Tue Aug 03, 2004 8:18 am
- License Nr.: 458
Ni(100) relaxation will not run.
please have a look at the error messages which are written (either on screen or into the job.o and job.e files). Do they give any hint of what may have happened? If NO output is generated I suppose that the executable is not found, or generated for a different processor type,...
Last edited by admin on Wed Dec 22, 2010 12:27 pm, edited 1 time in total.