Blank output with NGZhalf

Questions regarding the compilation of VASP on various platforms: hardware, compilers and libraries, etc.


Moderators: Global Moderator, Moderator

Locked
Message
Author
dfcox
Newbie
Newbie
Posts: 16
Joined: Wed Jun 22, 2005 1:19 pm
Location: Blacksburg, VA, USA

Blank output with NGZhalf

#1 Post by dfcox » Thu Aug 07, 2008 4:16 pm

Hi,

I am trying to install VASP to our Mac OSX cluster, using mpich 1.2.5 compiled with xlf90.

It compiles without a problem, but when I run it I get a blank output. No errors, No warnings. Just this:

Code: Select all

==============================================
n99(0):  POSCAR, INCAR and KPOINTS ok, starting setup
n99(0):  WARNING: wrap around errors must be expected
n99(0):  FFT: planning ... 1
n99(0):  reading WAVECAR
All nodes terminated successfully.
=============================================
We don't have the same problem with gamma point only (wNGZhalf). I don't know what else to put here, but please let me know if you need any other information.

Any suggestions?

Thank you very much in advance!
Last edited by dfcox on Thu Aug 07, 2008 4:16 pm, edited 1 time in total.

support_vasp
Global Moderator
Global Moderator
Posts: 1817
Joined: Mon Nov 18, 2019 11:00 am

Re: Blank output with NGZhalf

#2 Post by support_vasp » Wed Sep 04, 2024 12:11 pm

Hi,

We're sorry that we didn’t answer your question. This does not live up to the quality of support that we aim to provide. The team has since expanded. If we can still help with your problem, please ask again in a new post, linking to this one, and we will answer as quickly as possible.

Best wishes,

VASP


Locked